1. The boiler equipment should be inspected and cleaned before installation, and all components should be damaged.
2, the installation must be responsible for the person, the furnace workers to participate, and equipped with foreman, fitter, crane, etc., organize relevant personnel familiar with the drawings and materials.
3. The installation location should be close to the water vapor location, reduce pipeline investment and heat loss, and at the same time, water supply and sewage discharge are convenient, and sewage should be connected to the trench to avoid boiling water.
4. Make the foundation according to the foundation map and draw the boiler installation baseline.
5. The smokestacks should be installed firmly, and the number of drawstrings should be no less than three. When passing through the house, the rainshield should be added, and the joints of the flanges should be tight.
6. Install pipes, valves, instruments and accessories on site according to the requirements of drawings and boiler layout.
7. The ash pit cover is self-care, but it needs to be flat and cannot leak a lot.

Horizontal atmospheric hot water boiler use:

It can provide heating and domestic hot water for hotels, schools, baths and other enterprises and institutions.

Horizontal atmospheric hot water boiler instructions

Horizontal atmospheric hot water boiler inspection and cooking furnace

(1) The use and maintenance of horizontal atmospheric hot water boilers must be handled by a special person, and the furnace workers should be familiar with the boiler structure. Understand the performance and operational requirements of the boiler.

(2) If the water level of the horizontal atmospheric hot water boiler is two-thirds, observe whether the water level drops or not, and check whether the manhole, hand hole, drain valve and scale hole are leaking.

(3) The components of the horizontal atmospheric hot water boiler can be cooked after inspection and safety. The boiler can be made of soda ash or sodium phosphate. The amount of the boiler can be 5Kg per cubic meter of boiler volume. It should be made into 20% solution and burned. Hours, stop burning water temperature down to below 700.

(4) Check whether the valve is flexible and reliable before ignition.

(5) Check the pipe joints, the valves and furnace doors are tight and the switch is flexible and reliable.